Welcome to RocketLab Blog

The photo above is how the three individual parts, marked by the topmost splitting line of the wing body, will look like. After the three...

Due to the problem in the previous post, I have to cut out the third layer of the upper wing body. Firstly, as I did before, I split the...

Everything seemed to be going on smoothly... However, when I woke up on a Saturday morning, the filament was again stuck in the stepper...

Using a vernier caliper, I found out that the distance from the ground by which the upper part of the wings started not printing due to...

These are the newly designed cone and wings. The cone is mostly the same as the previous version other than that its minimum diameter is...

Although on the photo the wings seem to be matching with the PVC pipe perfectly, it is not. The friction between the wings and the PVC...

While printing out the wings for Mk.1, I realized that their size relative to the PVC pipe body is too small. Still, I decided to fully...

As evident on the photo, the cone cannot fit into the pipe because its minimum diameter (the part where it must smoothly fit with the...

Progress check 1 Progress check 2 The CAD model was designed by myself. The procedure video for this is on my CAD Design website (link:...