Moojo Kim
Making Rocket Body (12): Finished rocket structure
The photo below is the finished actual structure of the rocket module of Mk.1, composed of the cone, a 0.75m PVC pipe, and three sets of...
top of page
Welcome to RocketLab Blog
Here, I upload the fascinating works we produce in RocketLab. Scroll down to check out our earliest news!
검색
Moojo Kim
2020년 9월 7일1분 분량
Making Rocket Body (11): Printing new cone
Next, I moved on to printing out the cone again. The cone was relatively easy to print out because it was smaller and so took less time...
Moojo Kim
2020년 9월 6일1분 분량
Making Rocket Body (10): Wing body assembled
After the three identical leftover parts a printed, these are the 6 pieces that needs to be assembled together: Firstly, before they are...
Moojo Kim
2020년 9월 5일1분 분량
Making Rocket Body (9): Finishing wing body printing
The photo above is how the three individual parts, marked by the topmost splitting line of the wing body, will look like. After the three...
Moojo Kim
2020년 9월 5일1분 분량
Making Rocket Body (8): Third layer of upper wing body
Due to the problem in the previous post, I have to cut out the third layer of the upper wing body. Firstly, as I did before, I split the...
Moojo Kim
2020년 9월 5일1분 분량
Making Rocket Body (7): Filament problem again
Everything seemed to be going on smoothly... However, when I woke up on a Saturday morning, the filament was again stuck in the stepper...
Moojo Kim
2020년 9월 5일1분 분량
Making Rocket Body (6): Printing unprinted upper part of wings
Using a vernier caliper, I found out that the distance from the ground by which the upper part of the wings started not printing due to...
Moojo Kim
2020년 9월 5일1분 분량
Making Rocket Body (5): Designing and printing new wings
These are the newly designed cone and wings. The cone is mostly the same as the previous version other than that its minimum diameter is...
Moojo Kim
2020년 9월 4일1분 분량
Making Rocket Body (4): Wings also not smoothly matching
Although on the photo the wings seem to be matching with the PVC pipe perfectly, it is not. The friction between the wings and the PVC...
Moojo Kim
2020년 9월 4일1분 분량
Making Rocket Body (3): Printing out rocket wings
While printing out the wings for Mk.1, I realized that their size relative to the PVC pipe body is too small. Still, I decided to fully...
Moojo Kim
2020년 9월 4일1분 분량
Making Rocket Body (2): Cone does not fit into the PVC pipe smoothly
As evident on the photo, the cone cannot fit into the pipe because its minimum diameter (the part where it must smoothly fit with the...
Moojo Kim
2020년 9월 4일1분 분량
Making Rocket Body (1): Printing out the cone
Progress check 1 Progress check 2 The CAD model was designed by myself. The procedure video for this is on my CAD Design website (link:...
bottom of page